Open Sunday–Friday 7 AM–7 PM · Closed Saturday Cedarhurst · Hewlett · Lawrence · Woodmere · Inwood 4.7 on Google (14) Call (516) 490-0931
Split-level home with a raised-panel sectional garage door

Cables · Drums · Tracks · Rollers

Off-Track Door & Cable Repair Five Towns, NY

A door that jumped its track or hangs lower on one side is held by uneven tension and can fall. Leave it where it is. We reset doors, replace lifting cables, and straighten or replace bent track across Cedarhurst, Hewlett, Lawrence, Woodmere, and Inwood.

  • Same-Day Visits
  • Free Written Estimate
  • Sun–Fri 7 AM – 7 PM

Keep the Opener Off

If the door sits crooked, a roller has left the track, or a cable is hanging loose, leave the remote and wall button alone. Each attempt bends the track further or pulls the door out of the opening. Do not try to drive out under it; call (516) 490-0931.

Common Causes

Why Garage Doors Come Off Track

Most derailed doors trace back to one of these.

A Bump From the Car

A tap from a bumper can push the bottom section and bend the track just enough for the rollers to pop out.

A Cable Slipped or Snapped

When one cable lets go, that side drops and the rollers twist out of the track.

Worn Rollers

Rollers with cracked wheels or dry bearings can climb out of the track, especially on older doors.

Loose Track Brackets

Years of vibration loosen the bolts. A track that moves when you push on it is an early warning.

Something in the Way

A bike or trash can under a closing door, with the sensors out of line, can knock the door sideways.

Lifting Cables

What Lifting Cables Do and Why They Fail

Two steel cables are fastened at the bottom corners of the door and wind onto drums on the spring shaft above. They carry the door as the springs wind and unwind. A cable that is frayed, kinked, or rusted near the bottom bracket can let go with no warning, and the door drops on that side.

We always replace both cables together so both sides lift evenly. Galvanized cable is our standard, and stainless steel is available. For homes right on the water in Lawrence and Inwood, stainless usually lasts longer.

With the cables off, we also check the drums for wear, the bottom brackets for rust, and the spring tension, since cable trouble and spring trouble often show up together.

Cable & Track PricingStarting From
Lifting Cables (both)$125
Stainless Steel Cables$155
Track Realignment$175
Roller Replacement (each)$35
Hinge Replacement (set)$80 – $160
Off-Track Door ResetQuoted on site
Written EstimateFREE

Starting prices. The full price is in writing before any work.

Rollers & Track

Noisy Rollers Often Come First

Many doors that end up off track were grinding or shaking for months before. Worn steel rollers develop flat spots; sealed nylon rollers with ball bearings run quieter and are easier on the track. Fixing the noise early is cheaper than resetting a derailed door later.

The Repair

How We Fix an Off-Track Door

  1. Secure the Door

    The door is clamped in place so it cannot shift while we work around it.

  2. Release the Tension

    Spring tension is let off safely before anyone touches a cable or a track.

  3. Reset and Replace

    Rollers go back into the track, bent sections are straightened or replaced, and new cables go on both sides.

  4. Balance and Test

    The springs are set again, the door is balanced, and the opener, sensors, and auto-reverse are tested.

Off-Track & Cable Questions

Questions About Derailed Doors and Cables

What to do, and what not to do, when the door is off track or a cable is loose.

Is it safe to open a garage door that is off its track?

No. A door out of its track is held unevenly and can fall. Do not use the opener or lift it by hand; keep people and cars clear and call (516) 490-0931.

What makes a garage door cable come off the drum?

Usually a sudden loss of tension: a broken spring, a door that hit something while closing, or an old cable that stretched. Once the cable goes slack, it can unwind off the drum.

Should I replace one garage door cable or both?

Both. The two cables age together, and pairing a new cable with an old one leads to uneven lifting. We replace them as a set, starting at $125.

Can a bent garage door track be straightened?

Small bends can often be straightened and re-anchored. A section that is kinked or twisted gets replaced, because the rollers will keep catching on it. We tell you which applies after we look.

Google Reviews

Reviews From Repair Customers

Quoted as written. 4.7 out of 5 on Google from 14 reviews (November 2026).

5 out of 5 stars.Google review

The old rollers on my tracking rails were making an absolute racket every single time I backed my sedan out. This local garage door company checked the balance and found out the tracking setup was completely warped. They replaced the warped steel rails and applied proper lube to the bearings during the garage door maintenance visit. Everything rolls open quietly now without that awful metal-on-metal scraping noise.

Arthur A.
5 out of 5 stars.Google review

My opener's lift chain completely derailed from the gear assembly, leaving our SUV totally trapped inside the bay. The tech arrived with all the correct replacement garage door parts right inside his work vehicle to fix the mechanism. He re-aligned the motor assembly and completed the entire garage door repair so we could finally get out of the house.

Trudy H.

Door Off Track or Cable Snapped? Call (516) 490-0931

Cable and track repair in Cedarhurst, Hewlett, Lawrence, Woodmere, and Inwood, Sunday through Friday.